How to Extend the Life of a Wood Fence

[ad_1]

A wood privacy, split rail or picket fence can add to your home’s beauty and security. They typically last about 15 years, but with proper maintenance you can prolong the life of your wood fence to 20 years or more.

New Fence Considerations

Western red cedar and redwood are commonly used for fences because
they resist decay and rot, but there are a variety of other wood types
available. Fence posts should be pressure-treated because they have
contact with the ground and are exposed to moisture and insects, but the
pickets, or vertical boards of the fence, don’t need to be
pressure-treated because they’re above the ground. Pressure-treated
lumber is infused with chemicals that help keep water and bugs from
damaging the wood.

When you have a new wood fence installed, wait about a year before
staining or painting it. This allows time for the wood and chemicals
used for pressure treating it to dry out. If the fence isn’t dry, you’ll
just end up sealing moisture in, which can lead to rot and decay.
Pressure-treated wood is protected from fungal decay and termites, but
it’s still subject to swelling, shrinking, cracking and warping, so it’s
important to perform some basic maintenance on your fence every two to
three years.

Wooden Privacy Fence

Inspect and Repair Each Year

Once a year, take a walk around your yard and inspect your fence for
signs of damage or rot. Replace broken boards, hammer in loose nails or
tighten screws. Check each section of the fence to make sure it’s
securely attached to the next one. If any sections of the fence are
leaning, make sure the posts are seated firmly in the ground. You may
need to replace the posts if they’re in poor condition. Check the hinges
and locks on your gates to make sure they’re secure and lined up
properly. You can lubricate them with automotive grease if needed.

Pressure-treated lumber isn’t completely resistant to water
intrusion, so any steps you take to minimize its exposure to moisture
will help prolong the life of the wood. Adjust sprinklers so they don’t
get the fence wet and cause the wood to rot or lead to the growth of
moss. Trim back bushes and vines so they don’t hang on the fence,
because they add weight and hold on to moisture. Make sure the area
around the fence has proper drainage so water doesn’t pool around the
posts. The soil at the base of each post should be firmly packed, and
have a slight slope away from the fence.

Clean Every 3 – 5 Years

Every two to three years, clean the wood to remove dirt, moss, mildew
and graying. Then, recoat with a UV inhibiting, water-repellant
coating. After making repairs, scrape off any moss or loose, peeling
paint until you can see new wood, and clean the fence with a pressure
washer.

If you notice mold on the fence, you can mix a solution of 20% bleach
to 80% mild detergent and spray it on the fence an hour before washing
it. This will help kill any mold spores and help prevent them from
growing back.

Reseal or Paint After Cleaning

Paint or stain should be reapplied every 3-5 years, if not sooner.
Use exterior oil-based stain or latex paint, which will seal out
moisture, prevent wood rot, limit the amount of weathering and extend
the life of the wood. Choose a stain or sealant with a UV inhibitor to
help keep the wood from turning gray. Let the wood dry for about a week
before applying a stain or sealant. You can use a brush or a power
sprayer with a tip that’s main for stain, which is thinner than paint.

If your fence needs to be repaired or replaced, call the professionals at Reddi Fence today at 316-858-0757 for a free estimate.

Resources
found on our website are provided as general guidelines, and Reddi
Industries does not assume any liability resulting from the provided
information.

[ad_2]

Source link

Leave a Reply

Your email address will not be published. Required fields are marked *